MoSys Announces New Bandwidth Engine IC for Highest Random Access Performance

Optimizes Second Generation Architecture for Dual Port SRAM Type Random Access performance in Packet Processing and State Memory Applications

SANTA CLARA, Calif. — (BUSINESS WIRE) — October 10, 2012MoSys (NASDAQ: MOSY), a leader in semiconductor solutions that enable fast, intelligent data access for network and communications systems, today announced a new second-generation Bandwidth Engine® IC optimized for advanced random access performance of 100G, 200G and 400G networking applications. The device is based on a dual-ported, single-bank, partitioned architecture that substantially cuts random access cycle time, enabling a dramatic increase in the processing rate capability of networking equipment. The Bandwidth Engine family of ICs is designed and built for high reliability, carrier-grade applications.

The new device, MSR720, will extend Bandwidth Engine capabilities through the ability to simultaneously read and write to a specific memory location. The unique device architecture maintains full data coherency, high command efficiency and simplified scheduling, resulting in a performance of up to 4.5 Giga-Accesses per second (GA/s). The high access rates and reduced effective cycle time of the MSR720 access device are well suited to the requirements of state memory and queuing applications, where repeat access of the same address is needed.

Using 16 SerDes lanes at 15 Gigabits per second (Gbps), the MSR720 interface operates at 480 Gbps, providing the host with up to 270 Gbps CRC protected, effective data throughput. The device also supports 36-bit half-word write capabilities which improve the command bus utilization. The culmination of these features improves performance beyond the capability of standard memory subsystems, while occupying less board area, using fewer interface pins, and consuming less power.

Network system access rate requirements far exceed the access rate at which traditional solutions can enable real-time access to packet header data. The second generation Bandwidth Engine architecture will close this performance gap for customers with its MSR720 device architecture and will deliver on these requirements, resulting in the highest performance single chip networking memory solution available today.

“Our second generation Bandwidth Engine architecture will support purpose-built variants to optimize specific applications and access types," stated John Monson, Vice President of Marketing for MoSys. "The addition of true random access functionality and faster effective cycle time in the MSR720 will deliver leading-edge performance in high data rate, low latency networking applications such as state memory, queuing and scheduling.”

MoSys’ Bandwidth Engine family of ICs utilizes the GigaChip™ Interface, an open, 90 percent efficient, reliable transport protocol optimized for chip-to-chip communications. The device is compatible with CEI-11G and XFI SerDes which allows a seamless interface with high performance FPGAs, as well as standard libraries available from ASIC providers. A complete package of RTL and tools is available to support the Bandwidth Engine interface.

MoSys' first generation Bandwidth Engine IC has been fully qualified for carrier-grade applications and is available for volume production now. For information about Bandwidth Engine pricing and availability, contact a local MoSys sales representative at

Forward-Looking Statements

This press release may contain "forward-looking statements" about MoSys, including, without limitation, expected benefits of the Bandwidth Engine ICs, product development of Bandwidth Engine ICs, the capabilities and adoption of the GigaChip Interface, and anticipated benefits and performance results expected from the use of MoSys' ICs.

Forward-looking statements are based on certain assumptions and expectations of future events that are subject to risks and uncertainties. Such statements are made in reliance upon the safe harbor provisions of Section 27A of the Securities Act of 1933 and Section 21E of the Securities Exchange Act of 1934. Actual results and trends may differ materially from historical results or those projected in any such forward-looking statements depending on a variety of factors. These factors include, but are not limited to:

  • customer acceptance of Bandwidth Engine ICs;
  • difficulties and delays in the development, production, testing and marketing of Bandwidth Engine ICs;
  • the anticipated costs and technological risks of developing and bringing ICs to market;
  • the willingness of our manufacturing partners to assist successfully with the fabrication of Bandwidth Engine ICs;
  • the availability of quantities of ICs supplied by our manufacturing partners at a competitive cost;

and other risks identified in MoSys' most recent reports on forms 10-Q and 10-K filed with the Securities and Exchange Commission, as well as other reports that MoSys files from time to time with the Securities and Exchange Commission. MoSys undertakes no obligation to update publicly any forward-looking statement for any reason, except as required by law, even as new information becomes available or other events occur in the future.

1 | 2  Next Page »

Review Article Be the first to review this article

Featured Video
Latest Blog Posts
Jim SparksGISCafe Guest
by Jim Sparks
Maps are (Still) Important Again
Applications Programmer Analyst I for Southern Nevada Health District at Las Vegas, Nevada
Applications Programmer Analyst II for Southern Nevada Health District at Las Vegas, Nevada
GIS Project Manager for VHB at Wethersfield, Connecticut
Upcoming Events
Smart GEO Expo 2020 at COEX Hall C Republic of Korea Seoul Korea (South) - Aug 19 - 21, 2020
Defense Services Asia (DSA) 2020 at Kuala Lumpur Malaysia - Aug 24 - 27, 2020
IWCE 2020 Conference at Las Vegas Convention Center LAS VEGAS NV - Aug 24 - 28, 2020
ENVI Analytics Symposium (Virtual EAS) at CO - Aug 25 - 27, 2020
University of Denver GIS Masters Degree Online
UAV Expo2020 -Register   & save

© 2020 Internet Business Systems, Inc.
670 Aberdeen Way, Milpitas, CA 95035
+1 (408) 882-6554 — Contact Us, or visit our other sites:
AECCafe - Architectural Design and Engineering EDACafe - Electronic Design Automation TechJobsCafe - Technical Jobs and Resumes  MCADCafe - Mechanical Design and Engineering ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy PolicyAdvertise